molanis.com/forum - Tools for MetaTrader : The place to ask about the best expert advisor builder, expert advisor downloads, and expert advisor programming

I have no idea why this will not work. Everything looks good to me.

@ molanisfx/admin, do you you have any ideas?

Note: The EA that passed this working properly, but it works only if the candle is above the previous and current across the candle! What I need is to make the crossing in the same K and D candle!

Oh, ok. If you want to ignore the previous candle, delete your Shift 1 TA blocks.

Note that without your MA's as filters, you will be trading every time K ticks above or below D (quite often).

I actually tried to do this, but it did not work! Do not open any order! The. Mol in this post earlier! Try and you will not work.

You could take a look at the user guide that shows different cross overs. The issue here is that when using shift 0 you cannot look at the signal after the fact. If you use shift 0, you trade at the open of the bar when open=close=high=low, so all your indicators will be calculated using the open (the first tick); then the bar continues and receives more ticks and at the end you get the last tick (close). Mt4 plots the last tick. If you look at the chart you may think, it's not trading fine, what you see is the values at the close but you are trading at the open.
If you use shift 1 and shift 2 to define the cross, what you see in the chart really matches the trading. You need to define what is better for you, use the current or the previous bar; take into account the limitations of using shift 0

Actually I need to operate the crossing based on the same candle, the candle and not before, as sometimes happens and only the candle later it opens a new order, and when it opens!

If you don't want to wait for the next closed candle to confirm your entry, try changing Completed Bars to Every Tick in your START icon. Delete all Shift 1 TA blocks and only use Shift 0. This should trade every tick.

For the reasons molanisfx says, neither visual nor automated backtesting will be accurate.

That's how you say? Attached is the file .mol

No. You had 2 buy conditions negating each other, and 2 sell conditions negating each other. Delete entire Shift 1 TA for BUY, and delete entire Shift 1 TA for SELL (see attached). Your START icon looks ok.

Reminder: Use your MA's to filter your entries, otherwise you will be in and out every few milliseconds.

So ... what I need is this: If the line 'K' is above the 'D' and then cross below the line 'D' Sell. Or if you happen to be selling a cross in the same candle, the candle and not later. Vice vesa to buy. Is it possible? Buy or sell only at the crossing of these lines!

If I leave only sell if the line 'K' is below the 'D' without crossing each candle every tick or open a new order, and that's not good!

I think I understand.